EP7342-0002 | EtherCAT Box, 2-channel motion interface, DC motor, 48 V DC, 4.5 A, M12, with incremental encoder
connection
2 | Rx+
3 | Rx-
4 | Tx-
2 | A2
3 | B1
4 | B2
5 | n.c.
3, 4 | GND Motor
5 | n. c.
2 | V Enc
3 | A Enc
4 | B Enc
5 | C Enc
2 | V Enc
3 | A Enc
4 | B Enc
5 | C Enc
2 | +24 V DC UP
3 | GND
4 | GND
EP7342-0002 | EtherCAT Box, 2-channel motion interface, DC motor, 48 V DC, 4.5 A, M12, with incremental encoder
The EP7342-0002 EtherCAT Box enables direct operation of two DC motors. The speed or position is specified by the automation device via a 16 bit value. By connection of an incremental encoder (24 V DC, single-ended), a simple servo axis can be realized. The output stage is protected against overload and short-circuit. The EtherCAT Box has two channels that indicate their signal state via light emitting diodes. The LEDs enable quick local diagnostics.
Product status:
regular delivery
Product information
| Technical data | EP7342-0002 |
|---|---|
| Protocol | EtherCAT |
| Bus interface | 2 x M8 socket, 4-pin, a-coded, shielded |
| Number of outputs | 2 |
| Connection method | M12 socket, 5-pin, a-coded |
| Rated load voltage | 8…48 V DC |
| Load type | DC brush motor, inductive |
| Nominal voltage | 8…48 V DC |
| Output current | per channel max. 3.5 A (short-circuit proof, common thermal overload warning for both output stages) |
| Distributed clocks | yes |
| PWM clock frequency | 32 kHz with 180° phase shift each |
| Duty factor | 0…100% (voltage-controlled) |
| Resolution | max. 10 bit current, 16 bit speed |
| Power supply connection | feed: 1 x M8 male socket, 4-pin, a-coded; downstream connection: 1 x M8 female socket, 4-pin, a-coded |
| Electrical isolation | 500 V |
| Configuration | adaptation and optimisation of the respective motor via the controller |
| Current consumption from US | 120 mA |
| Special features | travel distance control, encoder input |
| Weight | approx. 165 g |
| Operating/storage temperature | -25…+60°C/-40…+85°C |
| Vibration/shock resistance | conforms to EN 60068-2-6/EN 60068-2-27 |
| EMC immunity/emission | conforms to EN 61000-6-2/EN 61000-6-4 |
| Protect. rating/installation pos. | IP65/66/67 (conforms to EN 60529)/variable |
| Approvals/markings | CE, ATEX |
| Ex marking | II 3 G Ex nA IIC T4 Gc |
| Housing data | 8 x M8, 4 x M12 |
|---|---|
| Dimensions (W x H x D) | 30 mm x 126 mm x 26.5 mm |
| Material | PA6 (polyamide) |
| Installation | 2 fixing holes 3.5 mm diameter for M3 |
Loading content ...
Loading content ...
Loading content ...
Loading content ...
Loading content ...
© Beckhoff Automation 2024 - Terms of Use